You are here.
Third and subsequent years
• The tree’s leader and scaffolds are allowed to elongate. Lateral growth normally is retained unless too vigorous, showing dominance on a scaffold or on the central axis. Lowest scaffolds are allowed to elongate at a 30- to 45-degree slope. When the two low scaffolds from adjacent trees pass the second wire, they are crossed and tied together at the middle of the second wire. Some repositioning of the tie on the first wire may be necessary to develop an even slope in the scaffold. Any strong lateral growth from these scaffolds showing dominance is headed at approximately 6 inches to either a downward or lateral growing shoot. One-year wood over 12 inches in length is usually pruned in half. If a terminal in a scaffold sets fruit, the fruit is removed and the leader renewed.
• Lateral shoots usually develop naturally on the central leader. At each trellis wire, a pair of suitable laterals is selected to become scaffolds. These should arise approximately 3 to 4 inches below the wire. Laterals are inclined and attached to give about a 45-degree slope. Later in the season, these are repositioned at approximately 30 degrees. If a young scaffold is not sufficiently long to be positioned, it may be marked for later identification, which is easily done with a spring clothespin. Growth may be enhanced by tying to about 60 degrees. Any strong lateral growth below and/or immediately above a pair of selected shoots is removed.
• This procedure for developing scaffolds is followed at each wire or level in the trellis. However, if suitable laterals fail to develop naturally, a heading cut may be made similar to that done at planting. The cut should be at or near a trellis wire for laterals to arise about 3 to 4 inches below the wire.
• Annual pruning is both summer and dormant pruning. Summer pruning is in August, about three months after bloom, and is considered mainly a grooming operation. All vertical vigorous growth from the top of the trellis is removed, which reduces shading, aids in suppression of the vigor in the top scaffolds, and maintains a hedgerow height of 6 feet. In addition, all vertical growth within the hedgerow itself is removed, but this may be done at any time during the summer. Further, all lateral shoots 12 inches or longer are stubbed by heading back to three basal shoot leaves, or to about 1/2 or 3/4 inches. This August stubbing of shoots is the most important pruning of the year and is what distinguishes the Penn State system. Besides increasing the exposure of bearing wood and maturing fruits to sunlight, stubbing enhances the development of bearing wood by manipulating vigorous growth into short shoots and spurs. Dormant pruning is largely heading back of older bearing wood, making corrective cuts, thinning out spurs, and, where necessary, re-stubbing to continue the control of vigorous wood.
• Feathered trees: A tree is planted vertically and oriented so that two feathers on opposite or nearly opposite sides of the tree occur approximately 14 to 15 inches from the ground (3 to 4 inches below the lowest trellis wire at 18 inches). These are inclined at a 45- to 60-degree slope, depending on length (vigor), and secured to the lowest trellis wire.
• If a suitable pair of feathers is located only above the bottom wire, training is possible for developing them into suitable scaffolds, provided they are located within 4 to 5 inches from the bottom wire. Training is a two-step operation. First, the basal part of a feather is bent horizontally or arched down to the wire. After tying, the remainder of the lateral is brought upward and fixed by dropping either a string or several ties attached together from the second wire. If of sufficient length, it is positioned at 45 to 60 degrees. Otherwise, it is just raised so that the terminal bud becomes the highest point. In a raised position, continued elongation of the young scaffold is assured. After sufficient growth, repositioning may be done. Thus, a high originating lateral may be made into a suitable scaffold. Its appearance would resemble that of a scaffold originating 3 to 4 inches below the bottom wire.